Acura 1994 Integra Service Manual page 1013

Hatch
Replacement
N O T E :
a An assistant is helpful when removing the hatch.
a Take care not to damage the hatch and body.
a Take care not to scratch the hatch side trims and hatch
tnm paner.
a Open the hatch.
a Remove the high mount brake light {see section 23).
1. Remove the hatch side trim on each side.
HATCH
< : Clip locations, 8
2.
Remove the hatch trim panel.
A : Clip localions
AA : Clip, 11
BV : Clip, 3
W', dtri
::::/ _:_/
HATCH TRIM PANEL
NOTE: Detach the clips by sliding the hatch trim panel
forward, then remove it.
3.
Remove the hatch spoiler as described on page
2 0 - 1 5 9 ( f o r s o m e t y p e ) .
4.
Disconnect the connectors, then remove the wire
harnesses from the hatch.
: Speclal bolt
locetlons,2
V : Clip locations
Av : Clip, 3
BA: CliP, 6
4
t + L
t f r l
l ' R @ t
,/ L,/
A
@
l
)
NOTE: Before pulling out the wire harness, tre a
strinq to the end of it so you can pull it back in when
the hatch is reinstalled.
HATCI{
WIRE I{ARNESSES
CONNECTORS
CONNECTOR
WIRE
HARNESS
20-146
5. Remove the rear wiper motor (see section 23).