Acura 1994 Integra Service Manual page 555

20. Connect the vehicle speed sensor (VSS), mainshatt
speed sensor and counterchalt speed sensor con
nectors.
VEHICLE SPEED SEiISOR
CONNECTOR
21. Connect the lock-uD control solenoid valve connec-
tor and shift control solenoid valve connector. then
clamp the lock-up control solenoid harness with the
harness stay.
22. Connect the transmission ground cable.
LOCK-UP CONTROL
SOLENOID VALVE
HARNESS STAY
23. Connect the starter cable to the starter motor, and
install the cable holder.
NOTE: When installing the starter motor cable,
make sure that the crimped side of the ring terminal
is facing out (see section 23).
CABLE
HOLDER
6 x 1 . 0 m m
'12 N.m (1.2 kgf'm,8.7 lbt.tl)
2 4 .
N . m
lO.9 ksr.m, 7 tbr-rtt
STARTER CAELE
Install the air cleaner housing assembly and intake
a r r o u c l .
AIR CLEANER HOUSING
ASSEMBLY
INTAKE AIR
DUCT
25.
26.
24.
2 9 .
30.
Retill the transmission with ATF(see page
'14-93).
Connect the battery positive ( + ) and negative ( - )
cables to the battery.
Start the engine. Set the parking brake, and shift the
transmission through all gears three times.
Check shitr cable adjustment as described on page
1 4 - 1 7 1 .
C h e c k t h a t f r o n t w h e e l a l i g n m e n t ( s e e s e c t i o n 1 8 ) .
Let the engine reach operating temperature (the cool-
ing tan comes on) with the transmission in S or @
position, then turn it off and check the fluid level.
3 1 . R o a d t e s t a s d e s c r i b e d o n p a g e 1 4 - 9 o a n d 9 1 .
14-167