Acura 1994 Integra Service Manual page 91

Cylinder Head
Installation (cont'dl
9. Apply liquid gasket to the head mating surtaces of
the No. 1 and No. 6 camshaft holders, then install
t h e m , a l o n g w i t h N o . 2 , 3 , 4 , a n d 5 .
NOTE:
o "1" or "E" marks are stamoed on the camshaft
holders.
. Do not apply oil to the holder mating surface of
camshaft seals.
. Apply liquid gasket to the shaded areas.
. T h e a r r o w s m a r k e d o n t h e c a m s h a t t h o l d e r s
should point to the timing belt.
N o . 6 N o . 5
N o . 2 N o . 1
10. Tighten the camshaft holders temporarily.
. M a k e s u r e t h a t t h e r o c k e r a r m s a r e p r o p e r l y
positioned on the valve stems.
INTAKE CAMSHAFT HOLDERS
11. Tighten each bolt in two steps to ensure that the
rockers do not bind on the valves.
6 r 1 . 0 m m
9.8 N.m 11.0 kgf.m,7.2lbtft)
Install keys into camshaft grooves.
NOTE: To set the camshafts at TDC position for No.
1 piston, align the holes in the camshafts with the
holes in No. 1 camshaft holders and insert 5.0 mm
pin punches in the holes.
I r 1.25 mm
37 N.m {3.8 kgf.m, 27 lbf.ttl
6 x 1 . 0 m m
9.8 N.m (1.0 kgf.m,
7.2 tbtft)
Push camshaft pulleys onto camshafts, then tighten
the retaining bolts to the torque specified.
KEYS
1 3 .