Blower Unit - Acura 1994 Integra Service Manual

Blower Unit
Replacement
NOTE: The blower motor, recirculation control motor
and blower resistor can be replaced without lemoving
t h e b l o w e r u n i t ( s e e p a g e 2 l - 2 1 ) .
1. Remove the glove box (see section 2O),
2. Remove the fou. bolts and the glove box frame.
Without Ail Conditioning
3-a. Remove the wire harness clips trom the heat€r duct.
Remove the Jour self-tapping screws 8nd the heat-
er duct.
GLOVE BOX FRAME
HEATER DUCT
With Air Conditioning
3-b. Remove the evaporator (see page 22-261.
CLIPS
6 x I
9.8
.ft 11.O kgt.m,
7.2 tbt.ftl
4 .
6 .
Oisconnect the connectors from the blower motor,
blower resistor and the recirculation control motor.
Remove the wire harness clip from the recirculation
control motor, and release the wire harness from the
clamo on the blower unit.
Remove the two mounting bolts, mounting nut and
the blower unit,
6 x 1 . 0 m m
6 x 1 . O m m
9.8 N'm (1.0 kgf'm.
7.2 tbt.ftl
lnstall in the reverse order of removal, and make sure
there are no air leaks.
9.8
.m (1.O kgl'm,
7.2 lbf'ft}
21-20
--