Brake Master Cylinder (12 343 0); Removal And Installation - Ford 2002 Bantam Workshop Manual

206-06-4

REMOVAL AND INSTALLATION

Brake Master Cylinder (12 343 0)

E9398 EN
Hydraulic Brake Actuation
Removal
CAUTION: If brake fluid is spilt on the
paintwork the affected area must be
immediately washed down with cold wa-
ter.
1.
Remove the brake fluid reservoir cap.
1. Disconnect the low brake fluid warning
2. Remove the cap.
2. NOTE: It will be necessary to carry out this
step on both sides in order to completely
drain the brake fluid reservoir.
Drain the brake fluid reservoir.
1. Connect one end of a suitable piece of
2. Loosen the bleed nipple.
3. Depress the brake pedal until all of the
4. Tighten the bleed nipple.
3.
Disconnect the clutch master cylinder hose
from the brake fluid reservoir.
CAUTION: The brake fluid reservoir
cap must not become contaminated.
indicator switch electrical connector.
clear plastic pipe to the bleed nipple and
place the other end into a suitable
container.
brake fluid is drained from the brake fluid
reservoir.
CAUTION: Cap the clutch master
cylinder hose to prevent fluid loss or
dirt ingress.
03/2001 2002 Bantam
206-06-4