Ford 2002 Bantam Workshop Manual page 844

303-06-206
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
A5: CHECK THE STARTER GROUND CIRCUIT
A6: CHECK B+ TO STARTER RELAY
Starter relay
E1017 EN
Starting System
1.
DETAILS/RESULTS/ACTIONS
2 Measure the voltage between the starter motor
terminal B, circuit 30 (RD) and ground.
• Is the voltage greater than 10 volts?
Yes
GO TO A5
No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
1 Measure the resistance between the starter
motor casing and negative (-) battery terminal.
• Is the resistance less than 5 ohms?
Yes
INSTALL a new starter motor. TEST the
system for normal operation.
No
CLEAN and REPAIR grounds as required.
TEST the system for normal operation.
2 Measure the voltage between the starter relay
connector pin 5, circuit 30 (RD) and ground.
• Is the voltage greater than 10 volts?
Yes
GO TO A7
No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
303-06-206
07/2001 2002 Bantam