Cable - Idle Speed Control - (Adjust) - Ford 2002 Bantam Workshop Manual

303-04D-32
GENERAL PROCEDURES (CONTINUED)

Cable - Idle Speed Control - (Adjust)

Equipment
WDS
E6449 EN
Fuel Charging and Controls — 1.8L Diesel Engine
NOTE: The idle speed control cable can only be
adjusted with the aid of the WDS.
Adjust
1. Connect the WDS to the vehicle data link
connector and select Idle Cable Adjust
option from the Toolbox menu.
2. Remove the idle speed control cable
retaining clip.
3. Using WDS, extend the idle speed control
motor plunger, by using the plus (+) icon.
Note: When adjusting the idle speed control
cable, the practice of pushing rather than pulling
must be used to prevent stretching of the outer
cable.
4. Push the outer section of the idle speed
control cable away from the idle lever until
the idle lever is pulled against the high
idle screw and refit the retaining clip.
5. Exit the Idle Cable Adjust screen and
disconnect the WDS from the vehicle data
link connector.
6. Connect a tachometer to the engine in
accordance with the manufactures
instructions.
7. Start the engine and allow it to idle.
8. Move the main fuel lever so that the
engine speed rises above 1400 rev/min
and ensure that the idle speed control
cable pulls the idle lever against the high
idle screw and then backs off slightly. If
this does not occur, carry out the idle
speed control adjustment again.
9. Switch the engine off.
10. Disconnect the tachometer from the
engine.
303-04D-32
09/2001 2002 Bantam