Ford 2002 Bantam Workshop Manual page 987

308-03-97
ASSEMBLY (CONTINUED)
E4462 EN
Manual Transaxle
35. Engage fifth gear.
• Turn the fifth gearshift rod clockwise as
far as the stop.
36. Engage fifth gear.
• Turn the main shift rod clockwise as far
as the stop and pull it out.
37. Adjust the selector finger.
1. Turn the main shift rod clockwise and
press it down.
2. Remove the end float of the selector
finger by lifting it.
3. Tighten the bolt in this position.
38. On transmissions with a black end cover
apply end cover sealer evenly to the
mating face of the end cover.
39. Fit the cover and install the input shaft oil
seal.
1. Fit the end cover with the gasket.
2. Drive in the input shaft oil seal until it is
felt to reach its stop.
• Fit the assembly plug.
308-03-97
07/2001