Ford 2002 Bantam Workshop Manual page 226

206-04-2
REMOVAL AND INSTALLATION
Wheel and Tyre
E8680 EN
Wheels and Tyres
Removal
CAUTION: Do not use heat to loosen a
seized wheel nut. Heat may damage the
wheel and wheel hub.
1. Loosen the wheel nuts.
2. Raise and support the vehicle.
For additional information,
refer to Section 100-02.
3. Remove the wheel and tyre assembly.
Installation
1. WARNING: Remove the corrosion or
dirt from the mounting surfaces of
the wheel, wheel hub, brake drum or
brake disc, as this may cause the
wheel nuts to loosen and the wheel to
come off while the vehicle is in
motion. Failure to follow this
instruction may result in personal
injury.
Clean the wheel hub and mounting
surfaces.
2. Install the wheel and tyre assembly.
3. Lower the vehicle.
4. Tighten the wheel nuts in a diagonally
opposed pattern.
206-04-2
07/2001 2002 Bantam