Download
Share
Print this page
Ford Taurus 2002 Workshop Manual
  1. Manuals
  2. Brands
  3. Ford Manuals
  4. Automobile
  5. 2002 Taurus
  6. Workshop manual

Ford Taurus 2002 Workshop Manual

Automatic transaxle/transmission
Hide thumbs Also See for Taurus 2002:

Advertisement

Quick Links

Download this manual See also: Owner's Manual, User Manual
2002 Taurus/Sable Workshop Manual
SECTION 307-01B: Automatic Transaxle/Transmission — 4F50N

REMOVAL

Transaxle — 3.0L 4V
Special Tool(s)
Remover, Halfshaft
205-241 (T86P-3514-A) or equivalent
Lifting Bracket, Engine (3.0L 4V-V6)
134-00243 or equivalent
Support, Bar Engine
303-290A
Adapters for 303-290A
303-290A-01
Adapter for 303-290A (Support Leg)
303-290A-03A
Slide Hammer
100-001 (T50T-100-A)
Removal
1. Remove the battery. For additional information, refer to
2. Disconnect the mass air flow (MAF) sensor.
3. Disconnect the breather tubes.
4. Remove the engine air cleaner.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2H/~MUS~LEN/20/...
Section
414-01.
2002 Taurus/Sable Workshop Manual
Procedure revision date: 06/20/2001
12/26/2010
10

Advertisement

loading

Related Manuals for Ford Taurus 2002

Summary of Contents for Ford Taurus 2002

  • Page 1 2002 Taurus/Sable Workshop Manual SECTION 307-01B: Automatic Transaxle/Transmission — 4F50N 2002 Taurus/Sable Workshop Manual REMOVAL Procedure revision date: 06/20/2001 Transaxle — 3.0L 4V Special Tool(s) Remover, Halfshaft 205-241 (T86P-3514-A) or equivalent Lifting Bracket, Engine (3.0L 4V-V6) 134-00243 or equivalent Support, Bar Engine 303-290A Adapters for 303-290A 303-290A-01...
  • Page 2 2002 Taurus/Sable Workshop Manual 5. Remove the air filter assembly. 6. Remove the battery tray. 7. Disconnect the connectors. 8. Remove the electrical connector and the wiring harness from the bracket. 9. Remove the manual control lever cable. 1. Remove the nut. 2.
  • Page 3 2002 Taurus/Sable Workshop Manual 10. Disconnect the power steering sensor connector. 11. Disconnect the power steering harness and output shaft speed (OSS) sensor connector. 12. Disconnect the wiring harness from the shift cable bracket. 13. Disconnect the turbine shaft speed (TSS) sensor. 14.
  • Page 4 2002 Taurus/Sable Workshop Manual 15. Remove the nut from the coolant pipe bracket. 16. Remove the bolts. 17. Remove the nut for the cooling tube. 18. Install the engine lifting bracket. 19. Remove the upper cowl assembly. 1. Remove the wiper. 2.
  • Page 5 2002 Taurus/Sable Workshop Manual 20. Remove the lower cowl assembly. Remove the three screws. Remove the clip. 21. Remove the rear support brace. 1. Remove the bolt. 2. Remove the nut. 3. Remove the rear support brace. 22. Install the rear engine lifting bracket in the same location where the top bolt was removed from the rear support brace. 23.
  • Page 6 2002 Taurus/Sable Workshop Manual 25. Raise the vehicle. For additional information, refer to Section 100-02. 26. Drain the transmission fluid by lowering the transaxle pan. 27. Disconnect the front HO2S sensor connector. 28. Disconnect the rear HO2S sensor connector. 29. Remove the rear bolts from the front catalytic converter assembly. 30.
  • Page 7 2002 Taurus/Sable Workshop Manual CAUTION: If the steering gear is removed with the subframe, do not allow the steering wheel to rotate while the steering column intermediate is disconnected or damage to the clockspring can result. If there is evidence that the shaft has rotated, the clockspring must be recentered before the vehicle is driven. For additional information, refer to Section 501-20B.
  • Page 8 2002 Taurus/Sable Workshop Manual 39. Remove the transmission housing cover. 40. Remove and discard the four torque converter to flexplate nuts. 41. Position the high lift transmission jack under the transaxle. 42. Remove the transaxle retaining bolts. 43. Remove the transaxle retaining bolt. http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2H/~MUS~LEN/20/...
  • Page 9 2002 Taurus/Sable Workshop Manual 44. Remove the support bracket. 1. Remove the nuts. 2. Remove the bolts. 3. Remove the bracket. 45. Lower the transaxle assembly from the engine compartment. 46. Remove the rear engine support mount. 47. Remove the bracket. 48.
  • Page 10 2002 Taurus/Sable Workshop Manual http://www.fordtechservice.dealerconnection.com/pubs/content/~WS2H/~MUS~LEN/20/... 12/26/2010...

This manual is also suitable for:

Sable 2002