Ford 2002 Bantam Workshop Manual page 549

303-01D-45
IN-VEHICLE REPAIR (CONTINUED)
E6447 EN
Engine — 1.8L Diesel - Endura DE
20. Insert the timing tool in the camshaft
21.
22. Remove the special tools and tighten the
23. Seal the parting line between the bearing
24. NOTE: Clean the cylinder head gasket and
NOTE: Before fitting the gasket, coat it lightly
with engine oil.
groove. If it is not possible to insert the
timing tool into the slot on the camshaft,
repeat the adjustment from step 10.
CAUTION: To avoid engine damage
make sure that the pointer is within
range 'A'.
Check the position on the automatic timing
belt tensioner.
• If the pointer is in range A: continue with
the next step.
• If the pointer is not in range A:
repeat the adjustment procedure from step 10
blanking plug to 24 Nm.
cap and the cylinder head on both sides
with a thin bead of sealer (SPM-4G9112-
F/G).
check it for damage. Only renew if damaged.
If it is in good condition, it can be used
several times.
Fit the cylinder head cover.
1. Screw in the bolts.
2. Attach the PCV hoses.
303-01D-45
09/2001 2002 Bantam