Ford 2002 Bantam Workshop Manual page 144

205-04-11
REMOVAL AND INSTALLATION (CONTINUED)
E6365 EN
Front Drive Halfshafts
4. Detach the lower suspension arm from the
spindle carrier.
5. CAUTION: The axle stub nut can be re-
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Unscrew and remove the axle stub nut and
remove the washer.
• Press the axle stub out of the wheel hub
using a two-legged puller and tie the
halfshaft up using cable ties.
6. NOTE: Do not damage the boot.
Remove the boot.
• Remove and discard the clamping
straps.
• Slide the boot onto the halfshaft.
7. Remove the halfshaft.
• Pull out the front drive halfshaft from the
tripod housing.
used four times. Mark the nut.
07/2001 2002 Bantam
205-04-11