Ford 2002 Bantam Workshop Manual page 158

205-04-25
REMOVAL AND INSTALLATION (CONTINUED)
E6671 EN
Front Drive Halfshafts
4. Pack the constant velocity joint with high-
durability grease.
• Amount: 40 grams on each side.
5. NOTE: Tighten 0,8 mm thick boot clamps to
12 Nm and 1,1 mm thick boot clamps to 20
Nm.
Position the boot and using the special tool
and adapter secure the boot clamps.
6. Install the lower suspension arm and the
front wheel.
7. Lower the vehicle.
8. Tighten the wheel nuts and the front drive
halfshaft stub nut.
1. Using a 32 mm socket wrench, tighten
the front drive halfshaft stub nut and
secure it, using a lock pin.
2. Wheel nuts.
205-04-25
07/2001 2002 Bantam