Ford 2002 Bantam Workshop Manual page 422

303-01B-50
IN-VEHICLE REPAIR (CONTINUED)
E6636 EN
Engine — 1.6L / 1.3L RoCam
4. Using the special tool, remove the camshaft
5. NOTE: Slackening sequence.
NOTE: Keep the camshaft bearing caps in order
for installation.
6. Remove the camshaft bearing caps and the
Installation
1. NOTE: Make sure the sprocket alignment slot
in the camshaft is uppermost (12 o'clock)
when installing the camshaft.
NOTE: Apply a drop of hypoid oil (WSQ-
2C9002-AA) to each cam bearing (upper and
lower) half.
sprocket.
Slacken each bolt of the camshaft bearing
caps by one turn until the camshaft is
released.
camshaft.
Install the camshaft and tighten the bolts in
two stages.
1. Tighten each of the camshaft bearing
cap bolts by 90° degrees in the indicated
sequence.
2. Tighten the bolts to the specified torque
in the indicated sequence.
07/2001 2002 Bantam
303-01B-50