Input Shaft Oil Seal - Ford 2002 Bantam Workshop Manual

308-03-49
IN-VEHICLE REPAIR

Input Shaft Oil Seal

Special Tool(s)
Remover, oil seal
303-336 (21-151)
E1157 EN
Manual Transaxle
Material
Self-tapping screw 2,5
x 15 mm
Removal
All vehicles
1. Remove the clutch slave cylinder.
1. Remove the bolts.
2. Detach the clutch slave cylinder from the
clutch housing.
2. NOTE: Also see the following job step.
Punch mark the input shaft oil seal
• Punch mark the input shaft oil seal using
the special tool.
3. NOTE: Carry out this step only in the position
shown.
Remove the input shaft oil seal (cont.).
1. Input shaft
2. Radial oil seal
3. Closed ball bearing
308-03-49
Specification
07/2001