Ford 2002 Bantam Workshop Manual page 559

303-01D-55
IN-VEHICLE REPAIR (CONTINUED)
E6346 EN
Engine — 1.8L Diesel - Endura DE
3.
NOTE: All timing pins must be inserted
correctly. The crankshaft must touch the timing
pin.
NOTE: Slacken the camshaft timing belt
tensioner bolt by one quarter turn, so that the
timing belt tensioner presses against the timing
belt.
4.
5. Fit the belt tensioner.
CAUTION: Used timing belts must not
be re-tensioned.
Tension the timing belt.
1. Tighten the camshaft timing belt
tensioner bolt.
2. Tighten the camshaft timing belt pulley
bolts.
3. Remove the timing pin.
4. Remove the alignment pin and tighten
the blanking bolt to 24 Nm.
CAUTION: Position the alternator and
screw in the bolts finger tight. First
tighten the bolt on the pulley side,
then the rear upper long bolt and
finally the rear lower short bolt.
Install the alternator and connect it.
303-01D-55
09/2001 2002 Bantam