303-14-243
REMOVAL AND INSTALLATION
Engine Coolant Temperature (ECT) Sensor — Vehicles with 1.6L / 1.3L Engines
(21 190 0)
E6694 EN
Electronic Engine Controls
Removal
1. Drain the cooling system. For additional
information,
2. Disconnect the engine coolant temperature
(ECT) sensor electrical connector.
3. Remove the ECT sensor.
1. Remove the clip.
2. Remove the ECT sensor.
4. Remove and discard the O-ring seal.
Installation
1. NOTE: Install a new ECT sensor O-ring seal.
To install, reverse the removal procedure.
303-14-243
refer to Section 303-03.
07/2001 2002 Bantam