Installing Previous Firmware - AMX MST-1001 Configuration Manual

Install Factory Firmware system message
FIG. 48
3. Within five seconds, the Yes button will be enabled. At that time, select Yes to install the factory firmware and No to return to
the Install Firmware page.
4. If you choose Yes, the touch panel will reboot and restart with the factory default firmware.
To reset the touch panel to its original factory firmware from the panel bootup:
1. Immediately after the touch panel boots up, the device's splash page appears on the screen (FIG. 49). Press the three
indicator dots within the first three seconds, before they start moving, to reset the firmware.
Modero S Series splash page
FIG. 49
2. The new confirmation page informs you that a panel reset to its original factory firmware may result in a loss of data (FIG. 50).
Click Yes to confirm that you wish to continue the resetting process and click No to return to the splash page.
Factory Reset confirmation page
FIG. 50
3. The touch panel will now reset to its original factory firmware and restart.
NOTE: Resetting the touch panel to its original factory f irmware will remove all previous changes to the Settings pages.

Installing Previous Firmware

In certain circumstances, it may be necessary to revert to a previously installed version of the touch panel firmware.To reset the
touch panel to its previously installed firmware via the Settings pages:
1. From the Install Firmware page, select the Previous field.
2. A System Message window appears, asking "Are you sure you want to install the following firmware?", with the previous
firmware version listed below (FIG. 51).
Modero S Series Touch Panels - Configuration & Programming Manual
Press these three dots to reset the
panel to its original factory firmware
Settings Pages
32