Table of Contents
Advertisement
Password Settings Page (Cont.)
Enable/Enabled:
Report:
To change a previously established password:
1.
In the Password Settings page, press the button in the In Panel Password Change section for the particular password to be
changed.
NOTE: Password 5 is protected, and can only be changed by the Administrator.
2.
In the Password keyboard, enter the new alphanumeric password.
3.
Press Done when complete.
NOTE: Only one of the main passwords may be used to access the Protected Settings page. An individual user password may not
be used to access the Protected Settings page unless it matches one of the main passwords.
To list a new user within the User Access section
1.
Press a blank button in the User Access section.
2.
In the Name keyboard, enter the user's name or nickname and press Done when finished.
3.
In the Password keyboard, enter the selected alphanumeric password and press Done when finished.
4.
The new user's name will appear in the left column of User Access section. The password will also appear in the right column,
but its characters will be replaced with asterisks.
NOTE: No matter how many characters are in an actual password, the Password column in the User Access section will always
show f ive asterisks.
To change a User Access password
1.
Press the button corresponding to the user's name in the User Access section.
2.
In the Password keyboard, enter the user's password and press Done.
3.
Press the password button in the right column of the User Access section.
4.
Enter the new password into the Password keyboard and press Done.
To view all previous instances of users accessing the device:
1.
From the Password Settings page, press the Enable button to highlight it. The MVP-5200i will record all successful and
unsuccessful attempts to access the touch panel.
2.
Press the Record button to send a record to the network Master of all recorded attempts to access the device. This record may
be retrieved from the Master at any time.
NOTE: For more information on removing an MVP-5200i from a MVP-WCS-52 Charging Station, please refer to the Unlocking the
Touch Panel on page 22.
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
The Enable/Enabled button allows you to toggle between activating or deactivating the MVP panel
requirement of a user to enter a pre-defined password before removing the panel from a connected docking
station:
• Enable - does not prompt the user for a password, the docking station just releases the panel when the
security release pushbutton is pressed.
• Enabled - requires that a valid password from the User Access list be entered before removing a panel
from a docking station.
The Report button enables/disables reporting the panel's docking status to the Master.
Protected Setup Pages
68
Advertisement
Table of Contents
