Replacing The Battery; Axd-Cv6 Battery Replacement - AMX AXD-CV6 Instruction Manual

Replacing the Battery

There is one lithium battery on the touch panel card, with a life of approximately 2.5 years. It
protects stored commands and pages against a power outage. The battery is not used when DC
power is supplied to the touch panel. Write down the replacement date on a label by adding 2.5
years to the date of installation; attach it to the panel for future reference.
FIG. 21 Lithium battery and socket
Static electricity can damage electronic circuitry. Before removing the touch panel
circuit card from the enclosure, discharge any accumulated static electricity from your
body and flat-blade tool by touching a grounded metal object.
Before replacing the lithium battery, make sure you have a current copy of the pages stored in the
touch panel. This will avoid any inadvertent loss of data or service outage. To replace the lithium
battery, you will need a Phillips screwdriver and a non-conducting flat-blade tool to slip under the
battery to pry it up and out of the socket.

AXD-CV6 Battery Replacement

To remove the lithium battery from the touch panel:
1. Discharge the static electricity from your body by touching a grounded object and remove the
magnetically attatched the faceplate.
2. Removing the main unit:
!
!
!
3. Pull the touch panel forward until the whole unit slides out of the surface/wallbox.
4. Disconnect all the connectors to remove the touch panel from the conduit/wallbox or
equipment rack.
6" Color Video Wall Panel
From the BB-CV6 conduit/wallbox by carefully unscrewing the four-#4 screws from the
threaded inserts located along the sides of the housing. Refer to FIG. 2 on page 3 for
more information.
From solid/flat surface by carefully unscrewing the four-#4 screws from the threaded
inserts located along the sides of the housing. Refer to FIG. 4 on page 5 for more
information.
From a plasterboard (drywall) surface by carefully unscrewing the two screws from the
drywall clips. Once these drywall clips are separated from their screws, the drywall clip
set must be re-order from AMX before the unit can be mounted to this type of surface
again. Refer to FIG. 8 on page 7 for more information.
Replacing the Battery
47