Machine Trouble - Fuji Xerox DocuCentre 9000 User Manual

15 Problem Solving

Machine Trouble

If you think some trouble is occurring on the machine, check the machine status again.
15
476
Symptoms
Power is not Is the power switch on the
switched On. machine off?
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine?
Is power of the correct
voltage being supplied?
Display is dark. Is the <Power Saver>
button on?
Is the brightness dial set too
low?
Unable to print, Is a message displayed on
or the control panel's display?
unable to copy.
Is the printer mode [Offline]? Press the <Machine Status> button and
Is the power cord
disconnected from the
machine or the rear of the
rack?
<Online> Is the interface cable
indicator does disconnected?
not light even
though you
instructed it to
print.
Is the personal computer's
environment correctly set?
Is the required interface
set?
Check
Turn the power switch on.
Refer to "Power On / Off" (P.38).
Turn the power switch off and then firmly
plug in the power cord. Then turn the
power switch on.
Refer to "Power On / Off" (P.38).
Make sure that the power supply is 200 -
240 V (volts), 15 A (amperes).
Make sure that power of capacity
compatible with the specified maximum
power consumption of the machine (2.8 -
3.1 KVA) is being supplied.
The machine is in the Power Saver mode.
Press the <Power Saver> button on the
control panel to cancel the Power Saver
mode.
Refer to "Power Saver Mode" (P.40).
Use the brightness dial to adjust display
brightness.
Refer to "Control Panel" (P.44).
Follow the instructions displayed to solve
the problem.
confirm the [Printer Mode] in the [Machine
Status] screen. If [Printer Mode] is [Offline],
select [Online] in the [Printer Mode] screen.
Turn the power switch off and then firmly
plug in the power cord. Then turn the
power switch on.
Refer to "Power On / Off" (P.38).
Turn the power switch off, unplug the
power cord from the power outlet, and
check the interface cable connection.
For information about Network Settings, refer
to Network Administrator Guide.
Check the print driver and other
environment settings on the personal
computer.
Check the status of the interface port in
use.
For information about Network Settings, refer
to Network Administrator Guide.
Remedy