Fuji Xerox DocuCentre 9000 User Manual page 586

16 Specifications
16
584
Print Quantity Setup
HP-GL Mode
Hard Clip
Eject Command
Scaling
115 0 (Default): Protocol
1: Panel
2: Command
Sets the method for specifying the print quantity.
150 0 (Default): HP-GL
1: HP-GL/2
A graphics language can be selected.
151 0: Standard
2 (Default): Paper
Sets the size for the area where drawings can be made
(hard clip area).
[Standard]...Hard clip area for A4, A3, letter, and ledger
are the same as for the Hewlett Packard HP7550A. Hard
clip area for other paper sizes is the same as this M/C
printable area.
[Paper]...Make the hard clip area the same area as the
paper.
152 0 (Default): OFF
(SP) 1: ON
153
(SPO) Sets the command that indicates a drawing is finished.
154 When the command specified here is received, drawing
(NR) is terminated and the paper is ejected.
155 [Off]...Does not process as an eject command.
(FR) [On]...Processes as an eject command.
156 ON is set as the default for SPO only.
(PG)
157
(AF)
158
(AH)
159 0: OFF
1 (Default): ON
Determines the setting to either enlarge or reduce the
document size so that the document size fits the paper
size.
[OFF]...Prints in the same size without enlargement/
reduction, even if the document size and paper size are
different.
[ON]...Prints while enlarging/reducing the data on
document size so that it fits the paper size.