Fuji Xerox DocuCentre 9000 User Manual page 303

Auto Print
Set the time from the end of print job until the execution of next print job. Set the value
from 1 to 240 seconds, in one second steps. If you select [No], once the machine is
ready, printing can start immediately.
1
Select [Auto Print], and select
[Change Settings].
2
Select [Off] or [On].
3
If you selected [On], set the time.
Auto Power Saver
In power saving mode, there is a "low-power mode" and a "sleep mode", and when the
set time has elapsed, these modes are switched to in the following way, thus reducing
the power consumption.
Last operation on the machine
1
Select [Auto Power Saver], and
select [Change Settings].
2
Set low-power mode and sleep
mode.
From Last Selection to Low Power Mode
Set the time to go from last operation to low-power mode. Set the time from 1 to 240
minutes, in 1 minute increments.
Note
From Last Selection to Sleep mode
Set the time to go from last operation to sleep mode from 1 to 240 minutes, in 1 minute
increments.
Time Zone
Set the time difference from GMT.
• Set the time [From Last Operation to Low-power Mode] not to exceed the time [From Last
Operation to Sleep Mode].
Low-power mode Sleep mode
Common Settings
10
301