Loading Paper; Loading Paper In Trays 1 To 2 - Fuji Xerox DocuCentre 9000 User Manual

Loading Paper

This section describes how to load paper.
About types of paper loaded in trays
The machine automatically detects the size and orientation of loaded paper in trays.
The paper type, however, must be set. Normally, plain paper is set to each of the trays.
Change the paper type settings if you load other paper types. Paper can also be
named, and set as user-defined paper. Up to five paper types can be set as user-
defined paper.
For details about changing paper type, refer to "Paper Tray Attributes" (P.307).
About automatic tray selection
Automatic tray selection is active if [Auto] is selected for [Paper Select]. If the machine
judges that there are two or more corresponding trays in automatic tray selection, the
machine gives higher priority to the tray having the highest [Paper Type Priority] set at
[Tray Paper Type]. During automatic tray selection, trays whose [Paper Type Priority]
setting is set to [Off] are not targeted in [Automatic Tray Selection]. Also, if the [Paper
Priority] setting is exactly the same, automatic tray selection is determined by [Tray
Priority]
Note
For information about setting [Paper Type], [Paper Type Priority], [Paper Tray Priority], and setting the
paper substitute feature, refer to "Paper Tray Settings" (P.307).The same settings can also be made from
CentreWare Internet Services.
Adding paper
When the machine runs out of paper during copying or printing, a message is displayed
on the control panel. Add paper according to the displayed instructions. Copying or
Printing is automatically resumed when paper is added.
Note

Loading Paper in Trays 1 to 2

Following describes the procedure for loading paper in trays 1 to 2.
When the machine runs out of paper during copying or printing, a message is displayed
on the control panel display. Add paper according to the displayed instructions.
Copying or printing is automatically resumed when paper is added.
1
Pull out the tray towards you until it
stops.
Warning
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
Important • While the machine processes a job, do not pull the tray out that the job uses.
• Tray 5 (manual feed) cannot be selected in automatic tray selection.
• When the machine runs out of paper during copying or printing, select the tray containing the
paper of the same size and orientation that was being used for copying or printing, and
continue copying or printing (Auto Tray Switch feature). During this operation, a tray
containing paper of type whose [Paper Priority] setting is set to [Off] cannot be switched to.
• Fan the paper well before loading paper in a tray. It prevents paper from adhering to each
other and reduces paper jams

Loading Paper

9
271