Fuji Xerox DocuCentre 9000 User Manual page 127

1
Remove any paper clips and
staples before loading documents.
2
Adjust the movable document
guides to just touch the edge of the
document.
Note
3
Set the document facing up (side 1
for 2 sided document) in the
document feerder.
Note
When placing the document in the
Document Feeder, you can set
timing for lifting up the document
feeder tray.
For more information about settings, refer to "Document Feeder Tray Elevation" (P.323).
Document Glass
The document glass accepts single-sheet or book form documents of sizes up to 297
× 432mm (A3, 11 × 17 inches).
The document glass can auto-detect only documents of standard sizes. For documents
that of not of a standard size, input the size in the [Scan Size] field.
For information about entering document sizes, refer to "Scan Size (Specifying a Scanning Size)"
(P.158).
Note
Caution
Do not apply excessive force to hold thick document on the platen glass. It may break
the glass and cause injuries.
1
Open the document cover.
• When loading a large
document, such as A3, open
the document stopper
rightward.
• The <Confirmation> indicator
lights up when the document
is loaded correctly.
• The standard document sizes that can be auto-detected depend on the [Paper Size
Settings] in the System Administration mode. For more information, refer to "Paper Size
Settings" (P.318)
Scanning Procedure
125
4