Audio Tones - Fuji Xerox DocuCentre-II C3000 User Manual

11 System Settings
Auto Print
Set the time period to start the next print job after finishing a copy operation.
When [On] is selected, specify a value between 1 and 240 seconds, in 1 second increments.
If you select [Off], printing starts immediately after the machine is ready.
Printer Lockout Duration
The machine disables to print fax documents received and reports during a given period of
time.
If you selected [On], specify a starting time and an ending time to disable printing, in one
minute increments.
Note
11
Auto Power Saver
The machine is provided with the Low Power and Sleep modes as the power saving mode.
When a specified period of time has elapsed, the machine switches to these modes in the
following order to reduce power consumption.
Last selection on the machine
For more information, refer to "Changing the Power Saver Mode Change Interval" (P.33).
Note
From Last Selection to Low Power Mode
Specify a time period between the last operation and entering the Low Power mode in the
range from 1 to 240 minutes, in 1 minute increments.
Note
From Last Selection to Sleep Mode
Specify a time period between the last selection and entering the Sleep mode from 1 to 240
minutes, in 1 minute increments.

Audio Tones

Select whether or not to sound an alarm, for example when a job ends or a fault occurs.
Control Panel Select Tone
Select the sound to be made when a button displayed on the screen is correctly selected.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Control Panel Alert Tone
Select the sound to be made when a button that cannot be selected is selected, or an error
occurs.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
Machine Ready Tone
Set the sound for when the machine is ready to copy or print, after powering on, for example.
You can select the volume from [Soft], [Normal], and [Loud]. To disable the sound, select
[Off].
268
• A job which has already been activated before the starting time will be printed continuously
even after the starting time elapses.
• The print-disabled condition is canceled when you operate using the control panel after the
ending time.
• To enable printing during the printer lockout duration, select a job under [Current and
Pending Jobs] on the [Job Status] screen, and then select [Promote Job].
Low Power mode
• There is no setting to disable switching to the Low Power mode or the Sleep mode.
• Configure the [From Last Selection to Sleep Mode] time to be longer than the [From Last
Selection to Low Power Mode] time.
Sleep mode