Fuji Xerox DocuCentre-II C3000 User Manual page 487

Category
Error Code
C P F S M O
026-702
027-452
027-500
027-501
027-502
027-547
027-548
027-549
027-564
027-565
O [Cause] By Address Book operation, the number of
communications from the LDAP server to the machine
exceeded the machine's processing capability.
[Remedy] Operate Address Book after a while. If the problem
persists, contact our Customer Support Center.
O [Cause] The IP address already exists.
[Remedy] Change the IP address.
Refer to the Network Administrator Guide for details.
O O [Cause] Unable to resolve the SMTP server name when returning
e-mail.
[Remedy] Check on the CentreWare Internet Services if the SMTP
server settings are correct.
O O [Cause] Unable to resolve the POP3 server name when using the
POP3 protocol.
[Remedy] Check on CentreWare Internet Services if the POP3
server settings are correct.
O O [Cause] Failed to login to the POP3 server when using the POP3
protocol.
[Remedy] Check on CentreWare Internet Services if the user name
and password used in the POP3 server are correct.
O [Cause] SMB protocol error. An invalid character was detected in
the specified domain name.
[Remedy] Check with the network administrator for the domain
name.
Also, check if the domain name set on the machine is
correct, using the following procedure:
1. Enter the System Administration mode, and select
[System Settings] > [System Settings] > [Network
Settings] > [Remote Authentication Server/Directory
Service] > [SMB Server Settings].
2. Select the SMB server to check the domain name.
O [Cause] SMB protocol error. An invalid character was detected in
the specified user name.
[Remedy] Check with the network administrator for the user name.
O [Cause] SMB protocol error
[Remedy] Try again. If the problem persists, contact our Customer
Support Center.
O [Cause] SMB protocol error. The SMB server was not found.
[Remedy] Check if the connection between the authentication server
and the machine has been established via a network. For
example, check the following points:
Network cable connection
TCP/IP settings
Connection via Port 137 (UDP)/Port 138 (UDP)/Port 139
(TCP)
O [Cause] SMB protocol error
[Remedy] Try again. If the problem persists, contact our Customer
Support Center.
Cause and Remedy
Error Code
16
485