Fuji Xerox DocuCentre-II C3000 User Manual page 565

Hide thumbs Also See for DocuCentre-II C3000:

Table of Contents

The maximum scaling factor is 210% of the advanced hard clip area for each paper size

and the minimum scaling factor is 22.5%.

7. Restrictions When Plotting under Auto Layout

If the Printer is Equipped with Hard Disk(s)

When Auto Layout is used, print data is stored on the hard disk.

If the Printer is Not Equipped with hard disk(s)

When Auto Layout is used, print data is stored in layout memory.

The default layout memory is set at 100kbyte. Consequently, when print data

exceeding 100kbyte is received, a printer error occurs.

If this happens, change the Auto Layout memory capacity on the operation panel.

However, the Auto Layout memory capacity max is 5120kbyte. So, print data larger

than 5120kbyte cannot be received.

When using the Auto Layout function, we recommend the printer be equipped with a

8. Examples of Combinations of Each Function

The following are examples showing the print results that can be achieved by

combining various functions.

Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Paper Size,

Document Size

HP-GL2 Emulation

Unit: Plotter Unit