Changing The Paper Size For The Trays - Fuji Xerox DocuCentre-II C3000 User Manual

Changing the Paper Size for the Trays

The following describes how to change the paper size for the Trays 1 to 3.
Note • The paper types for the Trays 1 to 3 are preset. Normally, plain paper is set. When changing
• When setting a non-standard size paper, you must register the paper size in advance. For
• When using Tray 1, 2, or 3 to load envelopes/postcards, contact our Customer Support
For information on how to make copies on non-standard size paper, refer to "Paper Supply (Selecting
the Paper for Copying)" (P.54). For information on how to print on non-standard size paper, refer to the
print driver's online help.
1
Pull out the tray towards you until it
stops.
Note • While the machine processes
• Do not add new paper to the
2
Remove any paper loaded on the tray.
3
Pinch the lever on each paper guide
and move each guide further out.
4
Move the paper guides to their new
positions.
5
To secure the guides in position, release the levers.
6
Load the paper neatly against the
left-hand side of the tray.
Important • Do not load mixed paper types
• Do not load paper exceeding
the setting to a different paper type, change the paper quality settings to match the type of
paper to be loaded to maintain high print quality.
For more information on paper type, refer to "Paper Size/Type" (P.271).
information on registering the paper size, refer to "Paper Size" (P.271).
Center to have the tray replaced with a dedicated one.
a job, do not pull the tray out
that the job uses.
paper on the tray in order to
prevent paper jams or making
mistakes of paper loading.
Remove any paper remaining
in the tray and then load the paper on newly loaded paper.
into the tray. It may cause
paper jam.
the maximum fill line. It may
cause paper jams or machine
malfunctions.

Changing the Paper Size for the Trays

10
245