Stapler Faults - Fuji Xerox DocuCentre-II C3000 User Manual

Stapler Faults

Stapler Faults

The following describes stapler troubles when the finisher (optional) is installed.
Follow the procedures on the following pages when copies are not stapled or staples
are bent. Contact our Customer Support Center if the problem persists after you have
tried the following solutions.
Bent staple
Unstapled
If copies are stapled as shown in the figures below, contact our Customer Support
Center.
One side of staple rising up Staple bent in reverse direction
16
Flattened staple Entire staple rising up
Staple rising up with
center pressed in
517