Print Mode Settings; Allocate Memory - Fuji Xerox DocuCentre-II C3000 User Manual

Print Mode Settings

In [Print Mode Settings], you make settings relating to the printer feature.
When using CentreWare Internet Services, more detailed settings are possible. For more details, refer to
"CentreWare Internet Services" (P.224), and refer to the Network Administrator Guide.
The following shows the reference section for each item.

Allocate Memory...................................................................................................................... 303

Delete Form.............................................................................................................................. 305
Other Settings........................................................................................................................... 305
1
On the [System Settings] screen, select [System Settings].
For the method of displaying the [System Settings] screen, refer to "System Settings Procedure" (P.250).
2
Select [Print Mode Settings].
3
Select the item to be set or changed.
Allocate Memory
For each interface, set the memory capacity for the receiving buffer (temporary storage
for data sent from the client).
You can change the receiving buffer capacity depending on the pattern of use and
purpose. Increasing the receiving buffer capacity may allow a client to be released
sooner from an interface.
Important • If you change the memory capacity settings, the memory is reset, and therefore data stored
• It is not possible to assign more than the total memory. When the power is turned on, if the
Note • When a port is set to [Disabled], the corresponding items do not appear.
• Depending on the amount of data sent from the client, increasing the memory capacity may
PostScript Memory
Specify a value for the PostScript memory capacity from 16.00 to 96.00 MB in 0.25 MB
increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
• The maximum value that can be set varies according to the available memory capacity.
HP-GL/2 Auto Layout Memory
Specify the capacity for HP-GL/2 auto layout memory.
If a hard disk is not installed, data can be stored in the HP-GL/2 auto layout memory. You can
specify a value within the range from 64 to 5,120 KB in 32 KB increments.
Note • This feature appears when an Emulation Kit or PostScript 3 Kit is installed.
• The maximum value that can be set varies according to the available memory capacity.
Receiving Buffer - USB
Set the receiving buffer for USB.
You can specify the value within the range from 64 to 1024 KB in 32 KB increments.
in all memory areas is lost.
settings exceed the available memory capacity, they are automatically adjusted by the
system.
not change the time taken to release the client.
information, contact our Customer Support Center.

Print Mode Settings

11
303