Pki (Public Key) Settings - Fuji Xerox DocuCentre-II C3000 User Manual

11 System Settings
Directory Service for E-mail Address Book
Select whether to use an address book stored on the directory server.
Even when [Use] is selected, unless the following conditions are satisfied, the address
book of the directory server will not be started.
SMB Server Settings
SMB Server Setup
Select the server specification method from [By Domain name], [By Domain Name &
11
IP Address], and [By Domain Name & Server Name].
Server Domain Name
Enter the domain name of the server. Up to 15 characters are allowed.
Note
Important • Use the NetBIOS domain name for the domain name.
Server IP Address
Enter the server IP address using values from 0 to 255.
Note
Server Server Name
Enter the name of the server. Up to 64 characters are allowed.
Note
Important • Use the NetBIOS computer name or full computer name with DNS suffix for the server

PKI (Public Key) Settings

You can make the settings for SSL/TLS, S/MIME, and PDF/DocuWorks Signature.
Note
SSL/TLS Settings
Configure the settings of SSL/TLS.
Device Certificate - Server
Select a certificate to be linked.
SSL/TLS Communication
Select whether to enable or disable the SSL/TLS communications.
SSL/TLS Port Number
Set the SSL/TLS communication port number in the range from 1 to 65535.
Device Certificate - Client
Select a certificate to be linked.
300
The IP address of the directory server (primary) of the machine must be set
The IP address or Internet address of the directory server (primary) must be set
The port numbers used for LDAP communication must be set on the directory server
and the machine
• You can set this item when [SMB Server Setup] is [By Domain Name].
• You can set this item when [SMB Server Setup] is [By Domain Name & IP Address].
• 224.XXX.XXX.XXX to 255.XXX.XXX.XXX and 127.XXX.XXX.XXX cannot be set.
• You can set this item when [SMB Server Setup] is [By Domain Name & Server Name].
name.
• Before setting the HTTP-SSL/TLS communication or S/MIME, the device certificate must be
set. For information on the certificate, refer to the Network Administrator Guide.