Preliminary Steps; Removing The Defective Psu Module; Installing The New Psu Module; Concluding Steps - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Power supply
6.4.1

Preliminary steps

"Locating the defective server" on page 57
Ê
Ê Remove the AC power cord from its cable bracket and disconnect it from the
PSU module to be replaced as described in section
server from the mains" on page
6.4.2

Removing the defective PSU module

Ê Identify the defective PSU module using the server management software.
Ê Remove the defective PSU module as described in section
PSU module" on page
6.4.3

Installing the new PSU module

Ê Replace the defective PSU module as described in section
module" on page
6.4.4

Concluding steps

"Connecting the server to the mains" on page 118
Ê
Ê If applicable, switch on the server.
"Performing a fan test after replacing a defective fan" on page 145
Ê
174
63.
171.
168.
Upgrade and Maintenance Manual
"Disconnecting the
"Removing a
"Installing a PSU
TX300 S8 / RX350 S8