Preliminary Steps - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

9.6.3.1

Preliminary steps

"Disabling SVOM boot watchdog functionality" on page 127
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Open the side / top cover as described in section
page 68.
"Removing the system air duct" on page 81
Ê
"Removing the system fan holder" on page 330
Ê
"Removing the SAS expander board" on page 315
Ê
Ê Disconnect the SAS cables from the SAS RAID controller.
Ê Remove the SAS RAID controller from its slot as described in sections
"Removing the SAS RAID controller" on page 430
cards" on page
9.6.3.2 Installing a TFM module
Note on TFM modules
I
A TFM module is required in order to connect an FBU to SAS RAID
controllers D3116 and D3216. Three different TFM kits are available:
RAID controller
D3116 SAS RAID controller
D3216 PRAID EP400i
SAS 3.0 RAID controller
D3216 PRAID EP420i
SAS 3.0 RAID controller
TX300 S8 / RX350 S8
357.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Opening the server" on
(if applicable)
or "Removing expansion
TFM kit
TFM (LSZ:L3-25419-01)
TFM 4G (LSZ:03-25444-05)
TFM 8G (LSZ:03-25444-01)
441