Resuming Bitlocker Functionality - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Basic software procedures

5.2.15 Resuming BitLocker functionality

If BitLocker Drive Encryption has been suspended for maintenance purposes
(see section "Suspending BitLocker functionality" on page
enabled to complete the service task.
I
If BitLocker Drive Encryption has been suspended prior to replacing
components you won't be asked for a recovery key when rebooting the
server after the maintenance task. However, if BitLocker functionality has
not been suspended, Windows will enter recovery mode and ask you to
input recovery key for further booting.
Ê In this case, ask the system administrator to enter the recovery key in
order to boot the operating system.
Ê Ask the system administrator to enable the previously suspended BitLocker-
protection on the system volume, using the BitLocker Drive Encryption control
panel item:
For Windows Server 2008:
Ê Open BitLocker Drive Encryption by clicking the Start button, clicking
Control Panel, clicking Security, and then clicking BitLocker Drive
Encryption.
Ê Select the system volume, and click Turn On BitLocker.
For Windows Server 2008 R2 and above:
Ê Open BitLocker Drive Encryption by clicking the Start button, clicking
Control Panel, clicking System and Security, and then clicking BitLocker
Drive Encryption.
Ê Select the system volume, and click Resume Protection.
I
For further information on how to resume BitLocker drive
encryption, please refer to the Microsoft TechNet library at
http://technet.microsoft.com/library/cc731549.aspx.
Fujitsu service partners will find additional information (also available
in Japanese) on the Fujitsu Extranet web pages.
152 Upgrade and Maintenance Manual
125), it has to be re-
TX300 S8 / RX350 S8