Cabling The Sas Backplanes; Concluding Steps - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Ê Secure the HDD bay top cover to the chassis with five M3 x 4.5 mm screws
(see blue arrows).
Ê Secure the intrusion switch holder on the HDD bay top cover with one
M3 x 4.5 mm screw (see orange arrow).

7.3.10.7 Cabling the SAS backplanes

Ê Connect SAS and power cables to the 3.5-inch SAS backplanes as
described in section

7.3.10.8 Concluding steps

"Installing the system fan holder" on page 331
Ê
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
Ê Install HDD modules or HDD dummy modules into the additional HDD slots
as described in sections
and "Installing a 3.5-inch HDD dummy module" on page
I
For detailed information on HDD mounting order, refer to section
inch HDD configurations" on page
Ê When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
"Connecting the server to the mains" on page 118
Ê
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task:
TX300 S8 / RX350 S8
"8x 3.5-inch HDD SAS backplane cabling" on page
"Installing a 3.5-inch HDD module" on page 256
"Resuming BitLocker functionality" on page 152
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
241.
245.
261.
"3.5-
283