Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual page 699

Removing processors from the defective system board
Ê Carefully remove the processors from their sockets on the defective system
board as described in
V
Remove and reinstall one processor at a time. Do not remove the
second processor from the defective system board until the first
processor has been installed on the new system board.
Installing processors on the new system board
Ê Install the processors on the new system board as described in
"Installing the processor" on page
Installing protective socket covers on the defective system board
I
Since the defective system board is sent back for repair, protect the
delicate processor socket springs with a socket cover.
Figure 545: Closing the load plate
TX300 S8 / RX350 S8
section "Removing a processor" on page
513.
Upgrade and Maintenance Manual
System board and components
497.
section
699