Basic Information - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
Never attempt to disassemble a hard disk or solid state drive.
●
For further safety information, please refer to chapter
●
information" on page
7.1

Basic information

For best performance, the following mounting sequence is recommended:
– Solid state drives (SSDs) are always equipped before installing hard disk
drives.
– Hard disk drives / solid state drives with different capacities are installed
from highest to lowest capacity.
– Hard disk drives with different rotation speeds are installed from highest to
lowest speed.
– When installing hard disk drives with different bus technologies (SAS or
SATA), first install SAS drives and then SATA drives.
– Please refer to section
a complete overview of the mounting sequence.
– Install dummy modules into unused HDD / SSD bays.
184
45.
"2.5-inch HDD / SSD configurations" on page 185
Upgrade and Maintenance Manual
"Important
for
TX300 S8 / RX350 S8