Installing The Sas Raid Controller - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.2.3

Installing the SAS RAID controller

Ê Remove the SAS RAID controller from its protective packaging.
I
For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section
Figure 323: Installing the SAS RAID controller
Ê Carefully insert the RAID controller into PCI slot 10 and press down firmly
until it is fully seated in the slot.
I
For slot preferences, please refer to section
page 346.
428
"Preparing the SAS RAID controller" on page
Upgrade and Maintenance Manual
427.
"Basic information" on
TX300 S8 / RX350 S8