Upgrading Or Replacing Processors - Fujitsu PRIMERGY TX300 S8 Upgrade And Maintenance Manual

11.4

Upgrading or replacing processors

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.4.1 Preliminary steps
"Suspending BitLocker functionality" on page 125
Ê
"Disabling SVOM boot watchdog functionality" on page 127
Ê
"Locating the defective server" on page 57
Ê
"Shutting down the server" on page 62
Ê
"Disconnecting the server from the mains" on page 63
Ê
Ê When working on a rack-mounted server:
"Extending / removing the server from the rack" on page 64
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
page 68.
"Removing the system air duct" on page 81
Ê
"Removing processor heat sinks" on page 523
Ê
TX300 S8 / RX350 S8
Upgrade and Maintenance Manual
Average task duration:
20 minutes
(if applicable)
"Opening the server" on
Processors
507