Wsw14 (Auto Ans Facility Setting) - Ricoh G157 Service Manual

MAINTENANCE MODE

WSW14 (AUTO ANS facility setting)

Selector
No.
Frequency band selection (lower
1, 2 limit) for incoming calling signal
(CI)
Frequency band selection (upper
3, 4 limit) for incoming calling signal
(CI)
5–8 Modem attenuator
Selectors 1 through 4: Frequency band selection for incoming calling signal (CI)
These selectors are used to select the frequency band of CI for activating the
AUTO ANS facility. In the French models, if the user sets the PBX to OFF from the
control panel, the setting made by selectors 1 and 2 will take no effect and the
frequency's lower limit will be fixed to 32 Hz. (Even if the setting made by these
selectors does not apply, it will be printed on the configuration list.)
Selectors 5 through 8: No. of rings in AUTO ANS mode
These selectors set the number of rings to initiate the AUTO ANS facility.
G157
Function
5-56
Setting and Specifications
No. 1. 2.
0 0: 13 Hz
0 1: 15 Hz
1 0: 23 Hz
1 1: 20 Hz
No. 3. 4.
0 0: 30 Hz
0 1: 55 Hz
1 0: 70 Hz
1 1: 200 Hz
No. 5. 6. 7. 8.
0 0 0 0: Fixed to once
0 0 0 1: Fixed to 2 times
0 0 1 0: Fixed to 3 times
0 0 1 1: Fixed to 4 times
0 1 0 0: 1 to 2 times
0 1 0 1: 1 to 3 times
0 1 1 0: 1 to 4 times
0 1 1 1: 1 to 5 times
1 0 0 0: 2 to 3 times
1 0 0 1: 2 to 4 times
1 0 1 0: 2 to 5 times
1 0 1 1: 2 to 6 times
1 1 0 0 1 to 10 times
1 1 0 1: 2 to 10 times
1 1 1 0: 3 to 5 times
1 1 1 1: 4 to 10 times
SM