Wsw09 (Protocol Definition 1) - Ricoh G157 Service Manual

WSW09 (Protocol definition 1)

Selector
No.
1 Frame length selection
2 Use of non-standard commands
3, 4 No. of retries
5 T5 timer
6 T1 timer
Timeout for response from the
7–8 called station in automatic
sending mode
NOTE:
Selectors 1 through 5 are not applicable in those models which do not support
ECM.
Selector 1: Frame length selection
Usually a single frame consists of 256 octets (1 octet = 8 bits). For communications
lines with higher bit error rate, however, set selector 1 to "1" so that the machine
can divide a message into 64-octet frames.
NOTE:
The error correction mode (ECM) is a facsimile transmission manner in which
the machine divides a message into frames for transmission so that if any
data error occurs on the transmission line, the machine retransmits only those
frames containing the error data.
Selector 2: Use of non-standard commands
If this selector is set to "0," the machine can use non-standard commands (the
machine's native-mode commands, e.g., NSF, NSC, and NSS) for communications. If
it is set to "1," the machine will use standard commands only.
Selectors 3 and 4: No. of retries
These selectors set the number of retries in each specified modem transmission speed.
Selector 5: T5 timer
This selector sets the time length for the T5 timer.
Selector 6: T1 timer
This selector sets the time length for the T1 timer.
Selectors 7 and 8: Timeout for response from the called station in automatic sending
mode
If the machine (calling station) receives no response (no G3 command) from the
called terminal in automatic sending mode for the period specified by these
selectors, it disconnects the line.
SM
Function
No.
No.
5-51
MAINTENANCE MODE
Setting and Specifications
0: 256 octets 1: 64 octets
0: Allowed 1: Prohibited
3. 4.
0 0: 4 times
0 1: 3 times
1 0: 2 times
1 1: 1 time
0: 300 sec. 1: 60 sec.
0: 35 sec. 1: 40 sec.
7. 8.
0 0: 55 sec. (NA)
60 sec. (others)
0 1: 140 sec.
1 0: 90 sec.
1 1: 35 sec.
G157