Wsw05 (1St Dial Tone And Busy Tone Detection) - Ricoh G157 Service Manual

This setting is effective only when the flash function is selected for the
Search/Speed Dial key by using the function switch.

WSW05 (1st dial tone and busy tone detection)

Selector
No.
1–3 1st dial tone detection
Max. pause time allowable for
4
remote ID code detection
Busy tone detection in automatic
5, 6
sending mode
Busy tone detection in automatic
7
receiving mode
8 Not used
NOTE: Selectors 5 through 7 are not applicable in those countries where no busy
tone detection is supported.
Selectors 1 through 3: 1st dial tone detection
These selectors activate or deactivate the 1st dial tone detection function which
detects the 1st dial tone issued from the PSTN when a line is connected to the
PSTN.
Setting all of these selectors to "1" activates the dial tone detection function so that
the machine starts dialing upon detection of a dial tone when a line is connected.
(However, in those countries which support no dial tone detection function, e.g., in
the U.S.A., setting these selectors to "1" makes the machine start dialing after a
WAIT of 3.5 seconds.) For the detecting conditions of the 1st dial tone, refer to
WSW07 and WSW08.
Other setting combinations deactivate the dial tone detection function so that the
machine starts dialing after the specified WAIT (3.5, 7.0, 10.5, 14.0, 17.5, 21.0, or
24.5 seconds) without detection of a dial tone when a line is connected to the
PSTN.
SM
Function
No. 1.
No.
5-45
MAINTENANCE MODE
Setting and Specifications
2. 3.
0 0 0: 3.5 sec. WAIT
0 0 1: 7.0 sec. WAIT
0 1 0: 10.5 sec. WAIT
0 1 1: 14.0 sec. WAIT
1 0 0: 17.5 sec. WAIT
1 0 1 21.0 sec. WAIT
1 1 0 24.5 sec. WAIT
1 1 1 Detection (Without
WAIT)
0: 2 seconds 1: 1 second
5. 6.
0 0: No detection
0 1: Detection only after
dialing
1 0: No detection
1 1: Detection before
and after dialing
0: Yes 1: No
G157