Eeprom Customizing (Function Mode 74) - Ricoh G157 Service Manual

EEPROM Customizing (Function mode 74)

This function allows you to customize the EEPROM according to language,
function settings, and firmware switch settings. The customizing code list is given
below.
USA
Europe
Asia
Asia
NOTE: If you replace the controller board, make sure to carry out this procedure.
1. Enter the "Maintenance" mode.
2. Press the "7" and "4" keys in this order.
3. The current customizing code (e.g., 0001 for the U.S.A model) appears.
4. Enter the desired customizing code (e.g., 0054 for the Europe model).
5. The newly entered code appears.
NOTE: The machine does not work properly when an incorrect code is
entered.
6. Press the "Black Start" key for the machine to save the setting.
7. "PARAMETER INIT" appears on the LCD. The machine returns to the initial
display of the maintenance mode.
NOTE: If you press the "Stop/Exit" key or no keys are pressed for one minute
during the above procedure, the machine stops the procedure and
returns to the initial display of the maintenance mode.
SM
Destination
5-35
MAINTENANCE MODE
Code No.
0001
0054
0056
0040
G157