Wsw35 (Function Setting 13); Wsw36 (Function Setting 14) - Ricoh G157 Service Manual

WSW35 (Function setting 13)

Selector
No.
Max. detection period of dial
1–4 tone/busy tone during recording
of ICM
5–8 Not used.
NOTE: Selectors 1 through 4 are applicable to models equipped with internal
TADs.
Selectors 1 through 4: Max. detection period of dial tone/busy tone during recording
of ICM
If the machine (called station) detects dial tone or busy tone exceeding the
detection level specified by selectors 1 through 3 on WSW30 for the period
specified by these selectors, then it disconnects the line.

WSW36 (Function setting 14)

Selector
No.
1 ECP mode*
Recovery from Inactive PC
2
Interface
3 PC Power-off Recognition Time
4 Not used.
5 Escape from phase C
Extension of incoming calling
signal (CI) frequency band
6–8
specified by selectors 1 through 4
on WSW14
Selector 1: ECP mode (Not used.)
The ECP mode enhances the normal bidirectional communications between the
machine and the connected PC for higher transmission speed.
SM
Function
No. 1. 2. 3. 4.
Function
(Not used.)
(Not used.)
(Not used.)
No. 6. 7. 8.
5-77
MAINTENANCE MODE
Setting and Specifications
0 0 0 0: No detection
0 0 0 1: 1 sec.
0 0 1 0: 2 sec.
0 1 0 0: 3 sec.
↕
1 1 1 1: 15 sec.
Setting and Specifications
0: Yes 1: No
0 0 0: 0 (Ignored)
0 0 1: 4 (448 Hz)
0 1 0: 8 (244 Hz)
0 1 1: 12 (162 Hz)
1 0 0: 16 (122 Hz)
1 0 1: 20 (97 Hz)
1 1 0: 24 (81 Hz)
1 1 1: 28 (69 Hz)
*ECP: Enhanced Capabilities Port)
(Continue to the next page)
G157