1.2 INSTALLATION PROCEDURE
1.2.1 INSTALLING THE COPIER
See the Quick Setup Guide.
1.2.2 EEPROM CUSTOMIZATION
At the factory:
• Maintenance function 74 (see section 5.2.3). This inputs a code for the region,
such as Europe, Asia, etc.
1.3 MOVING THE MACHINE
Use caution when you move the machine:
You need two or more persons to move the machine. The machine weighs about
35 kg (77 lb) without optional units.Before you turn off the main power, move the
CIS to the shipping position with Maintenance function 06 (see section 5.2.3).
NOTE: The customer can do maintenance function 06 themselves. But you
must tell them to use this function before they move the machine.
2. Keep the machine level at the time you move it.
3. Put the machine on a flat area. Make sure that the whole part of the base
supports the weight of the machine.
4. Use the padding in the original package.
5. Remove these units before you move the machine:
• Photoconductor unit
• Optional paper feed unit
• Paper
NOTE: Do not remove the waste toner bottle. Waste toner may fall from the
waste toner path.
6. Protect the photoconductor unit surface with paper or cloth.
7. Clean the units and components in the copier.
8. Secure the paper tray and all exterior covers with tape.
SM
INSTALLATION PROCEDURE
1-3
G157