Wsw21 (Tad Setting 1) - Ricoh G157 Service Manual

Selectors 8: Limitation on CNG detection
If this selector is set to "1," the machine detects a CNG signal according to the
condition preset by selectors 2 and 3 on WSW18 after a line is connected. If it is
set to "0," the machine detects a CNG signal as long as the line is connected.

WSW21 (TAD setting 1)

Selector
No.
1–5 Max. waiting time for voice signal
6, 7 Taping the call
Erasure of message stored in the
8 memory after the message
transfer
NOTE: 1) Selectors 1 through 5 are applicable to models equipped with ICM
recorders.
2) Selectors 6 and 7 are applicable to models with internal TADs.
3) Selector 8 is applicable to models equipped with TADs.
Selectors 1 through 5: Max. waiting time for voice signal
In the TAD mode, the machine waits for voice signal for the time length specified
by these selectors before it automatically shifts to the facsimile message receive
mode or disconnects the line.
Selectors 6 and 7: Taping the call
These selectors select whether or not to tape the call. Setting them to "1, 0"
enables taping the call without signaling to the calling station that the call is being
taped.
Selector 8: Erasure of message stored in the memory after the message transfer
Setting this selector to "0" will erase the message recorded in the memory after the
document retrieval feature transfers the message.
SM
Function
No. 1. 2. 3. 4. 5.
No. 6. 7.
5-63
MAINTENANCE MODE
Setting and Specifications
0 0 0 0 0: No detection
0 0 0 0 1: 1 sec.
0 0 0 1 0: 2 sec.
0 0 0 1 1: 3 times
↨ ↨
0 1 0 0 0: 8 sec.
↨ ↨
1 1 1 1 1: 31 sec.
0 0: Enable (signaling for U.S.A.)
0 1: Enable (signaling for
countries except U.S.A.)
1 0: Enable (without signaling)
1 1: Disable
0: Yes 1: No
G157