Wsw02 (Tone Signal Setting) - Ricoh G157 Service Manual

MAINTENANCE MODE

WSW02 (Tone signal setting)

Selector
No.
Tone signal transmission time
1, 2
length
3, 4 Min. pause in tone dialing
Attenuator for pseudo ring
backtone to the line (selectable in
5–8
the range of 0-15 dB, in 1 dB
increments)
Selectors 1 through 4: Tone signal transmission time length and Min. pause in tone
dialing
These selectors set the tone signal transmission time length and minimum pause
[C] in tone dialing.
(Example: If "1," "2," "3," "4," and "5" are dialed.)
"1"
Selectors 5 through 8: Attenuator for pseudo ring backtone to the line
These selectors are used to adjust the sound volume of a ring backtone in the F/T
mode, an on-hold sound, or a beep generated as a signal during remote control
operation or at the start of ICM recording. The larger the value specified by these
selectors, the greater the attenuation.
G157
Function
"2" "3"
5-42
Setting and Specifications
No. 1. 2.
0 0: 70 ms
0 1: 80 ms
1 0: 90 ms
1 1: 100 ms
No. 3. 4.
0 0: 70 ms
0 1: 80 ms
1 0: 90 ms
1 1: 140 ms
No.5 0: 0 dB 1:
No.6 0: 0 dB 1:
No.7 0: 0 dB 1:
No.8 0: 0 dB 1:
"4" "5"
[C]
8 dB
4 dB
2 dB
1 dB
G157S503.WMF
SM