Wsw26 (Function Setting 4) - Ricoh G157 Service Manual

MAINTENANCE MODE

WSW26 (Function setting 4)

Selector
No.
1, 2 Not used.
Dialing during document reading
3 into the temporary memory in in-
memory message transmission
No. of CNG cycles to be detected
(when the line is connected via
4, 5
the external telephone except in
the external TAD mode or via the
built-in telephone)
No. of CNG cycles to be detected
(when the line is connected via
the external telephone in the
6, 7 external TAD mode, via the built-
in telephone in the TAD mode, or
via the machine in the automatic
reception of the F/T mode)
8 Not used.
Selector 3: Dialing during document reading into the temporary memory in in-
memory message transmission
If this selector is set to "0", the machine waits for document reading into the
memory to complete and then starts dialing. This enables the machine to list the
total number of pages in the header of the facsimile message.
Selectors 4 and 5: No. of CNG cycles to be detected (when the line is connected via
the external telephone except in the external TAD mode or via the built-in telephone)
The machine interprets a CNG as an effective signal if it detects the CNG by the
number of cycles specified by these selectors when the line is connected via the
external telephone except in the external TAD mode or via the built-in telephone.
Selectors 6 and 7: No. of CNG cycles to be detected (when the line is connected via
the external telephone in the external TAD mode, via the built-in telephone in the
TAD mode, or via the machine in the automatic reception of the F/T mode)
The machine interprets a CNG as an effective signal if it detects the CNG by the
number of cycles specified by these selectors when the line is connected via the
external telephone in the external TAD mode, via the built-in telephone in the TAD
mode, or via the machine in the automatic reception of the F/T mode.
G157
Function
5-68
Setting and Specifications
0: Disable
No. 4. 5.
0 0: 0.5
0 1: 1
1 0: 1.5
1 1: 2
No. 6. 7.
0 0: 0.5
0 1: 1
1 0: 1.5
1 1: 2
1: Enable
SM