Ricoh G157 Service Manual page 77

3) The LCD switches to the "Edit Mode" with a cursor.
4) Enter the serial number, which is given on the right side of the machine,
using the ten-key pad.
5) Press the "Menu/Set" key.
NOTE: The machine displays the newly entered ID code on the LCD for 0.5
second, and then returns to the initial stage of the maintenance mode.
To cancel the ID code entry, press the "Stop/Exit" key instead of the
"Menu/Set" key. The machine beeps for one second, and then returns
to the initial stage of the maintenance mode.
6. Do the CIS Scanner Area Setting (Function mode 55 in the "Maintenance
mode" 5.2.3).
7. Set the firmware settings with "Function mode 10" (
NOTE: Refer to the sheets, which have been printed in Step 2 of
"Replacement procedure".
8. Print the "Printout of firmware switch setting" again.
9. Make sure that the settings are the same as before.
Procedure 2
1. Plug in and turn on the main power switch of the machine.
2. "SET COUNTRY" and "PRESS SET KEY" appear alternately on the LCD.
NOTE: 1) If the customer is not specified or the setting is uncertain and the country
code setting needs to be done by the customer, press the "1" and "3"
keys at same time. This skips the "EEPROM customizing". The next
time that the main power is turned on, "EEPROM customizing" can be
done if necessary.
2) If these messages do not appear at this time, it means that the country
setting has already been done. Even so, the customer can change the
setting with "Function mode 74" in the Maintenance mode (
3. Press the "Menu/Set" key.
• Oceania Version: "AUSTRALIA" and "SELECT ↑↓ & SET" appear alternately.
• EUROPE version: "U.K" and "SELECT ↑↓ & SET" appear alternately.
4. Use the" " and " " keys to select the target country, and then press the
"Menu/Set" key.
5. The machine displays "ACCEPTED" on the LCD and returns to the stand-by
mode.
6. Do procedure 1.
SM
5.2.3).
3-35
CIRCUIT BOARD
5.2.3).
G157